Half Moon Mirror

Half Moon MirrorThis luxury half moon wall mirror features a sleek, modern design with a polished frame, adding elegance and sophistication to any space. Its curved shape creates a striking visual appeal, perfect for enhancing both contemporary and classic interiors. 6mm thick Silver Pilkington Optimirror Polished edges all round One tube of glue supplied Bespoke sizes available on request please feel free to contact us to discuss further. Please note: We can only

This luxury half-moon wall mirror features a sleek, modern design with a polished frame, adding elegance and sophistication to any space. Its curved shape creates a striking visual appeal, perfect for enhancing both contemporary and classic interiors.

• 6mm thick
• Silver Pilkington Optimirror
• Polished edges all round
  
• One tube of glue supplied

Bespoke sizes available on request please feel free to contact us to discuss further.

Please note: We can only deliver this product to a UK mainland address and to a ground floor only.

Mirror Fitting Instructions - Adhesive

Important Information

These instructions are for installing a single mirror using adhesive only.
Our recommended mirror adhesive is supplied with your order and must be used as directed for safe and long-lasting installation.

Mirror Backing Check

• Do not apply adhesive to safety-backed mirrors.
  Safety backing is a white or clear plastic film applied to the back of some mirrors for shatter resistance.

• Foil-backed mirrors (metallic in appearance) are suitable for adhesive fitting.
  Foil backing protects the mirror from adhesive damage and is safe to use.

Warning: Using the wrong adhesive or applying it to a safety-backed mirror may cause the glue to degrade the paint and silver backing over time.

Tools & Materials Required

• Tape measure
• Pencil
• Mastic gun
• Supplied mirror adhesive
• Stanley blade (for cutting nozzle)
• Glass suckers (optional, for easier lifting)
• Baton or temporary support (recommended for mirrors over 15kg)
• Low modulus neutral cure silicone (for sealing in wet areas)

Support Baton (Recommended for Heavy Mirrors)

• For mirrors over 15kg, we strongly recommend installing a temporary baton or ledge at the bottom to support the mirror while the adhesive cures.

• This prevents slippage during the drying process.

• A piece of skirting board or timber offcut works well. Ensure it's level and secure.

Surface Preparation

• Make sure the wall surface is clean, dry, and dust-free.

• Lightly mark the desired mirror position using a pencil and tape measure.

Adhesive Application

1. Lay the mirror on a soft, flat surface with the painted backing facing up.

2. Cut the nozzle of the adhesive tube with a Stanley blade and load it into a mastic gun.

3. Apply horizontal lines of adhesive approximately 10cm apart across the back.

4. Avoid applying adhesive too close to the edges to prevent squeeze-out when mounting.

Mounting the Mirror

1. Carefully lift the mirror (use glass suckers if needed) and position it on the wall.

2. If using a baton, gently rest the mirror on it for support.

3. Press the mirror firmly into place and hold it for at least 3 minutes.

4. The adhesive sets gradually—do not disturb the mirror while it cures.

Curing Time

• Allow the adhesive to fully cure for 24 hours before removing any supports or applying pressure.

• Ensure the room is at a stable ambient temperature to promote proper drying.

Sealing (Optional – For Wet Areas)

• For mirrors installed in bathrooms, kitchens, or other moisture-prone areas, we recommend sealing the edges.

• Apply a thin bead of low modulus neutral cure silicone around the back edge to protect the mirror from water and cleaning products.

• Our sealant is clear, but coloured versions are available if preferred.